The Zf 8hp transmission and CHCM Chassis Control ECUs replacement are possible with used units. However, the ECU needs to come from a car with the same engine and transmission combination. For example, one cannot take one of these ECUs from a Diesel engine car and install it in a Petrol one.

All 2017+ Send us the ECU Info for verifications of the Deployable Tow Bar ECU firmware version. Menu--ECU Info, use the send email button. No screenshot please. L405 and L494. There are two hardware version of the Tow Bar ECU. On earlier cars, this one was fitted, version A, HK6M19H544AK. It will support just towbar [...]

--Under testing-- This is to enable parallel and perpendicular parking assistance. Part of the Parking Aid system, it uses additional sensors. Not all model year support perpendicular assist. -Verify that the Park Assist Sensors are installed on the vehicle. There are two in the front bumper and two in the rear bumper. Total of the [...]

The following setting needs to be changed; Menu--Car Config--Complete List Radio, amp and speaker system, set it to Premium audio system

L405 L494 up to 2016 Menu--Car Config--Complete List; Dynamic button = Fitted L663 Menu--Car Config--Complete List; -EUCD-129 Terrain Response Fitment = Auto Terrain Response Dynamic & Configurable Dynamic Mode -MultiCAN-562 DynamicProgMode = Available for selection without timeout -EUCD-245 Dynamic-I = Dynamic-i Content with Configurable Dynamic Mode Screen

Only a brand new ECU purchased from Land Rover can be fitted. Used units cannot be installed. - Replace Module - ECU Info, Check Latest Firmware 7H32-14C184-AA and reflash if needed - Contact us and as for BCM replacement AsBuilt - Program Keys with special build (contact us) - Steering Column Calibration if fitted with

On some platforms, 2016+, the service reset may not work. Please contact us for assistance. On L550 Discovery Sport for example, an update of the IPC Instrument Pack ECU may be required. Always try the manual method first on 2017+ vehicles; Open the bonnet (hood) and close all doors Place the ignition to the ON [...]

Validated on a 2023 Menu--Car Config--Complete List; MultiCAN-636 AdaptDrvBeam set to AdaptDrvBeam Enabled MultiCAN-679 HeadlightsVariant set to Headlamp_Variant_High_A MultiCAN-674 AFS123 set to AFS123 Enabled

This item is under development. Details will be added as knowledge on the subject increases. Range Rover L322 2010 to 2012 and Rover Rover Sport L320 2010 to 2013; Install the correct parts (radar, switches) taken from a vehicle of the same model year and platform. Prior to reinstalling the bumper cover, proceed with the [...]